
Khay pin Flywing 450L V3 (Flywing 450L V3 Battery Tray)
- Downloads
- 100
- Likes
- 4
- Views
- 305
- Remixes
- 0
- Comments
- 0
Files 3 454.7 KB
- FlyWing_450L_V3_Battery_tray_2.4_top_v1_1776744231.stlSTL · 132.9 KB
- FlyWing_450L_V3_Battery_tray_2.4_top_v1_1776744232.f3dF3D · 261.4 KB
- FlyWing_450L_V3_Battery_tray_2.4_top_v1_1776744233.3mf3MF · 60.4 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #320706
- Category
- DIY
- Published
Description
Flywing makes amazing RC model helicopters that utilize GPS and other forms of stabilization. In my case I purchased a FW450L V3. A battery tray is an inexpensive part, but it is necessary to hold a battery pack inside the model. One tray comes with the model, but I wanted to have two more packs ready to go when I fly without dismounting and mounting the packs to the same battery tray. So I designed a battery tray for 3D printing. I also made the tray bottom 1mm thicker so that the pack would clear the main gear and one-way bearing. There is a slot for two-sided velro to hold the battery pack in place.
I sliced in PS 2.7.4 and printed the tray with Prusament PETG (always very slowly) with supports on build plate only and 0.2mm layer height, 40% gyroid infill. Used stock Prusament settings on a MK3S+ with Revo 6. Supports break free cleanly.
Print spec
- Formats
- 3mff3dstl
- Model files
- 3
- Total size
- 454.7 KB
- Largest file
- 261.4 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -

-

-

-

-
New -

-

-


