Skip to main content
F3D
Kẹp gắn sạc Pixel Watch cho Pixel Stand (Thế hệ 2) 1

8 images

DIY

Kẹp gắn sạc Pixel Watch cho Pixel Stand (Thế hệ 2)

By BradBarlow_291427

Downloads
203
Likes
28
Views
1,392
Remixes
1

Files 2 1.2 MB

  • Pixel_stand_v2_pixel_watch_charger_right_1776660933.stlSTL · 601.2 KB
  • Pixel_stand_v2_pixel_watch_charger_left_1776660934.stlSTL · 601.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

A minimalistic clip for the pixel watch charger to charge your pixel watch alongside your phone.

The aim was to make the clip as minimalistic as possible and not add any distance between the charger and the rear of the phone than necessary, with the peak design cases even 1mm would cause the phone not to charge so the minimalistic clips should still allow for wider compatibility. 

The clip does work straight off the print bed although I would recommend compressing the clip together so it has more clamping force when mounted on the pixel stand.

Included are both left and right variants for whichever suits. Feedback welcome.

This was very difficult to model as whoever is in googles design department dislikes right angles and even numbers, which would explain the slight gaps.

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
1.2 MB
Largest file
601.2 KB

0 comments

See all