Skip to main content
F3D
Insert PCAR thẳng cho Dart Zone Venom Pro đời cũ… 1

5 images

DIY

Insert PCAR thẳng cho Dart Zone Venom Pro đời cũ (dưới 130 FPS)

By Hoon_409951

Downloads
141
Likes
30
Views
1,486

Files 5 1.9 MB

  • Venom_PCAR_1776644259.stlSTL · 375.6 KB
  • Venom_PCAR_1776644261.stepSTEP · 473.2 KB
  • Venom_PCAR30_1776644262.stlSTL · 375.6 KB
  • Venom_PCAR25_1776644263.stlSTL · 375.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This only works for older models of the Venom Pro. Newer ones shoot hotter. Please find the remix that brings the FPS down further below 120. 

Got a Venom Pro but it's shooting too hot for 130FPS? Fear not!

An insert for the Venom Pro which features a 20mm Straight PCAR (no angle) to reduce the FPS of the blaster from 125-135 FPS to an average of 120 (tested numbers in Photos). This file is just called “Venom PCAR below”, and there is also a STEP.

This fileset also includes a version with 25mm and 30mm of PCAR action in case you need FPS reduced slightly further. Note that I don't have specific numbers tied to these two lengths, but they will be lower than the FPS from the standard 20mm PCAR.

Increased ID is a 30mm PCAR with an increased ID in the barrel leading into the PCAR lines.

These PCARs are inserts rather than barrel replacements because I wanted these PCARs to be installable and removable without the need to take apart the blaster. However, converting the PCAR into a barrel replacement would be trivial so that may be coming soon.

Read more Show less

Print spec

Formats
stepstl
Model files
5
Total size
1.9 MB
Largest file
473.2 KB

0 comments

See all