Máy ép in phantom 8 inch: kèm print settings và các bed đã layout

all credit to the original designer, I just sliced up the model in bambu so it's a littler easier to print and get started, I also consolidated the materials list so it is less easy to procrastinate. 

---

print settings

build guide

— parts list

- [ ] 2x press body 
- [ ] 3x pressure knob
- [ ] top roller (hex)
- [ ] bottom roller
- [ ] 2x bed support
- [ ] Gearbox cover
- [ ] Crank gear
- [ ] middle and hex gear
- [ ] handle and pin
- [ ] press bed 

— BOM

- [ ] 2 x 5/16x 3 inch threaded rod 
- [ ] 2 x 5/16 lock nuts 
- For my metric friends two 8mm-1.25 x 100mm threaded rods and two 8mm-1.25 lock nuts.
- [ ] Spring this one 
- [ ] super glue
- [ ] lubricant (I used lithium grease, but any PLA/plastic safe lube will probably work)

I was able to acquire everything at menards, most hardware stores should be able to get you need except maybe the springs, 

— 

two print changes I would consider, making the model 100% density around where the threads fit in, there was some disconcerting cracking and squeaking, and adding a brim around the press body, I had a very minor issue with warping that only effects looks.  

I had an extra piece of wood for the base, you do need one, it should be very easy to design and print, I don't believe the default one will work because it is made for the 6 inch stand. It would make a good first fusion or solidworks project!