Otto DIY Quadruped robot – Robot 4 chân DIY

Quad was inspired was inspired by #OttoDIY hat we all know ;) and MiniKame is a little quadruped robot based on an ESP8266 WiFi module. It has 8 servos (two per leg) and a small LiPo battery.

Features

• 👩💻 Simple Programming with Otto Blockly or Arduino
• 📃 Instruction manual included
• 👣 Walks & dances
• 🔊 Makes emotional sounds and melodies

Print instructions

Recommended to use a FDM 3D printer with PLA material.
No need supports or rafts.
Resolution: 0.3mm or 0.2mm for better resolution
Fill density: 15%

List of Parts

• 🖥 Otto Nano Microcontroller + I/O board
• 🔌 Micro USB cable
• 🔋 Rechargeable battery
• ⚙ 8 x micro servo motors with set of screws.
• 🔊 Buzzer
• 🌈 16 x DuPont cables
• Phillips screwdriver
• 3D Printed head (select from ultrasound or led matrix)
• 3D Printed body
• 3D Printed legs
• 3D Printed feet

We invested lots of time and resources to provide open source code, software and hardware, please support this project by just giving us a ❤ Like and share and you are welcome to be a part of this friendly community of robot builders, teachers and makers. Join today our Otto Builder community