Case màn hình ESP32 5 inch Touch IPS LCD cho 8048S050

ESP32 5inch Touch IPS LCD Screen Case

I recently purchase this screen from Ali Express.
ESP32-S3 HMI 8M PSRAM 16M Flash Arduino LVGL WIFI&Bluetooth 5 " IPS 800*480 Smart Display Screen 5.0 inch RGB LCD TFT Module.

It's a gorgeous 800 x 400 IPS screen that looks stunning with capacitive touch.

I decided to model a close fitting case with a rear cover that snap fits to the front case portion.

The case is a snug fit around the pcb so depending on your printer it may be necessary to allow more clearance around the pcb.

If that is the case then it is recommended to increase the scale of the front case and the rear cover in your slicer software. Or amend the files.

The rear cover has spacer legs on each corner to hold the pcb in position.

A separate stand file is included to enable the case to sit tilted to 60 degrees.

Separate files are also included for the Front Case with no holes (except USB C)

Printed at 0.20mm with no supports required.

STEP files are included should you need to make amendments.

Hope this helps someone.