Adapter quạt Blower 120mm cho Nvidia Tesla P40 (thẳng)

A quick and dirty (emphasis on dirty) hack of HojoWork's 90 degree 120mm blower duct.  Removed the bend so you can conceivably mount 2+ cards on the same board.  Requires supports to print.  

The first one I printed worked out fine, but the screw bracket broke off the second one during install.  Upon inspection, it's no wonder.  There's very little “meat” attaching the bracket to the rest of the model.  I added a few gussets to the “V2” version that should make it a lot sturdier.

V2.1 is broadly the same as V2, but I removed the manual fan speed control mount and cleaned up a few of the faces a bit.

Works great on the P40.  Probably works on other tesla cards as well.  P40 + fan + mount is about 17.5" (440mm) tip to tail.

See the original model description for compatible fan/speed controller.