Adapter quạt 120mm cho Sim Hub Wind Sim (Wind Ace)

This is a conversion for the Wind Ace Wind Simulation for Sim Hub that converts the back so it takes a 120mm fan.

There is an adapter for the body so a fan can be fitted and then a rear flow guard for the back.

I used the GDSTIME GDP1238 Axial Fan which is PWM, runs off 12v PSU with the PWM single provided by the Arduino just don't forget to link the GND!   Very impressive performance. 

I talk through my design and the build process a bit more on my website at https://byteinsight.co.uk/2022/06/simhub-wind-sim/

You will need some hardware and I generally suggest people buy those assorted boxes from a certain online retailer.  To construct the fan you will need:

• 1 x M8 Hex Nut
• 1 x M8 x 25mm Bolt
• 1 x M6 Hex Nut
• 1 x M6 x 45mm Bolt
• Multiple M3 Heated Inserts (See note below). 
• Various M3 Bolts.  inclucing 4 x 50 M3s to attach the back.
   

Heated Inserts appear to come in two types - the narrower ones with less holding power and then the chunky ones with twisted knurls..  Because of the available material and number of bolts I have used the former on the fan body but the latter thicker ones on the fan back.