Chặn Bánh Xe Ghế Low-Profile (Remix)

This remixed version of the Chair Wheel Stopper by Luoti is designed for racing game enthusiasts who need a stable chair during gaming sessions with a wheel and pedal setup. The model has been slightly modified for efficiency:

• Lower Profile: Reduced height to minimize plastic use and printing time, without affecting its functionality.

• Central Hole: Added in the middle to further reduce material usage and optimize print time while maintaining durability.

Dimensions:

Should fit wheels up to 60mm diameter (the stopper itself is 54mm wide). Tested on Herman Miller Mirra, Aeron, and Embody chairs, but it should fit most office or gaming chairs with similar wheel sizes.

Don’t Skip This!

To prevent sliding on smooth floors, apply some non-slip silicone or rubber to the bottom. Here’s an example of what you can use: https://www.amazon.com/Slip-Adhesive-Silicone-Cuttable-Furniture/dp/B09VFB7QVF). If you’re using the stopper on a mat, you might not need this step.

Pro Tip: I printed it in PLA, but if you prefer, you can print this in TPU instead and skip the rubber application. TPU’s flexibility should provide built-in grip on most surfaces.
 

Printing Suggestions for PLA:

- Infill: 15 - 20% should be enough. Use a rectilinear or grid pattern for strength while minimizing material use.
- Support: Not needed.

--

Shoutout to Luoti for the original design! This remix keeps the spirit of the original while making it more efficient to print. Happy racing! 🏎💨