Giá đỡ thẻ Micro SD nhỏ gọn

In contrast to the original SD card holder there is a little hook to secure the card even more and the size has been adjusted to fit a micro SD card.
The card snaps in with a nice click.
To remove the card, bend the hook slightly downwards and at the same time push the card out with pressure from above or use your fingernail to push at the edge of the card.

I used PETG and printed with 0.1mm layer height, but 0.2mm should also work fine.
Also I printed with 100% infill and 5 perimeters.
No supports needed.