
Máy In 3D
Ngàm kẹp và Adapter cho xích dẫn cáp Flashforge Adventurer 5M
- Downloads
- 1,394
- Likes
- 155
- Views
- 7,889
- Remixes
- 2
- Comments
- 0
Files 2 196.8 KB
- AD5M_Drag_Chain_Clip_-_OMv1.5_1776356531.stlSTL · 90.3 KB
- AD5M_Drag_Chain_Adapter_-_OMv1.5_1776356531.stlSTL · 106.5 KB
Make a variant with AI
Build another version of this model.
Remix versions 2
Riser Dragchain cho Flashforge Adventurer 5M/5M ProByPeterGB_2730469 · 04/18/2026
Ngàm kẹp xích (Drag Chain Clips) cho Flashforge Adventurer 5M (AD5M) dùng xích 10x15Byschr · 04/16/2026
Details
- Model ID
- #302821
- Category
- Máy In 3D
- Published
Description
I modeled the the drag chain clip as seen in the instruction manual for the Flashforge Adventurer 5M DIY enclosure.
Drag chain clip
- This was designed to fit with Lauren Mills' drag chain model.
- I used a 16mm M3 screw for the drag chain clip
- As per the instructions, you need to remove the top cover of the extruder, unplug the cable and pass it through the clip.
Adapter
- The adapter is fragile, be careful when removing supports and installing
- It uses the original screws and an M3 heat set insert - check your insert sizing outer diameter as they can vary
Both models need supports.
Remember to turn off and even unplug your machine before installing upgrades.
I have limited experience 3D modeling and used TinkerCad to model these.
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 196.8 KB
- Largest file
- 106.5 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -
New -
New -

-

-

-

-

-


