Ngàm gắn Beacon Offset cho Stealthburner

This mount works with the beacon probe normal configuration plug. I remixed this because I bought the wrong sensor but decide to make it work.  The sensor is reversed from the original so the wire travels inside the Stealthburner x-carriage like the old proximity sensor.  I like the fact that the wire isn't exposed and doesn't effect the performance of the sensor.

This requires 2 heat sets installed from the underside. And it will mount into the space for the old proximity sensor and reuse the tiny rear mounting part with the two heat sets.

I used a y_offset of 32 mm in my printer config settings.  I haven't had any heat problems with my new probe. I did add the gold heat reflecting/resistant tape to the wires as a precaution.