Grid Tổ Ong Cho Đèn Flash Ngàm Bowens S

A 3D printable strobe grid for the Bowens S-mount which is standard on a lot of medium or larger studio strobes. The length and size of the grid allows an approximately 20° cone.

I would not suggest using this with a non-LED modeling light for both the length and heat generated, but suspect HTPLA or better would be fine for an LED light and lower power strobe discharges.

Recommend 3 wall thickness and using the least supports possible to fully support the grid.

Model has been verified on my strobe and works as expected. 30W COB modeling light makes it warm but not enough to consequentially soften standard PLA and wouldn't affect HTPLA.