Skip to main content
F3D
Giá đỡ đèn pin cho tay lái xe đạp 1

4 images

Dụng Cụ Tiện Ích

Giá đỡ đèn pin cho tay lái xe đạp

By Vrimech_968116

Downloads
132
Likes
44
Views
1,170

Files 4 576.5 KB

  • Mount_1_1765454542.stlSTL · 265.9 KB
  • Button_1765454551.stlSTL · 91.7 KB
  • Rubber_Seal_1765454558.stlSTL · 1.1 KB
  • Mount_2_1765454562.stlSTL · 217.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

I made a mount for attaching a cheap flashlight to bike handle bars. I don't bike much so I didn't want to buy a dedicated bike light (and I enjoy any excuse to design something).

It's designed to grip onto both  a 1" (or in my case 1.08") diameter flashlight and 1" diameter bike handlebar.

The two mounts were printed from PLA, using 4 perimeters and 30% infill at .1 mm layer height (though .15 or .2 mm would likely work just fine). The rubber seals were printed from TPU. The seals were just a fun experiment and not necessary. They could be replaced with some grippy tape on the inside of the mounts or might work without anything at all.

The two mount parts were glued together using Scigrip 16 methyl glue and the seals and nuts were attached with superglue (for convenience only). The flashlight mount uses stainless steel, 8-32 x 5/8" screws and the handlebar grip uses 8-32 x ½" screws (but could use 5/8" as well, or significantly longer). Square 8-32 nuts were embedded in the mount.

I bought this flashlight from Menards:

https://www.menards.com/main/lighting-ceiling-fans/flashlights-accessories/guidesman-reg-1000-lumen-rechargeable-flashlight/gm-1000rfl-612/p-1566455468964-c-6314.htm?tid=92b0b961642ea5e8&ipos=15

Read more Show less

Print spec

Formats
stl
Model files
4
Total size
576.5 KB
Largest file
265.9 KB

0 comments

See all