Vỏ bảo vệ Fishball SDR Case

All antenna connectors and ports are exposed, only the microSD card is not accessible without disassembly (which isn't typically required, as it can be accessed via USB).

Hardware required:

• 4 * M2x6 SHCS (top half)

• 4 * M2x8 SHCS (bottom half)

• 4 * M2x12 female/female standoffs (between board and top half)

  • alternative: 4 * M2x6 female/female and 4 * M2x6 male/female standoffs

• 8 * M3x5x4 heat-set inserts (Voron-style)

• 1 * 30x30x7 5V 2-pin fan ("3007", typically ~7.5mm thick)

• 4 * M3x16 SHCS (for the fan mount)

The mounting hole pattern on the back is 30x30mm.

When designing mounts, make sure to pick a bolt length doesn't protrude too deep into the case (<= 5mm from the outer surface of the back side) to prevent any damage to the board.

I have included a couple of variations of the Top (No Fan, GPIO Pins, Skeletonized) and Bottom (No Mounting Holes, Skeletonized), but i think the default (Fan, Mounting Holes, No GPIO Pins) is the best choice.