
Giá đỡ gắn tường cho Zooz ZEN58 Surface Mount
- Downloads
- 1
- Likes
- 0
- Views
- 78
- Remixes
- 0
- Comments
- 0
Files 1 388.2 KB
- zse58_mount_1775552546.stlSTL · 388.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #290280
- Category
- DIY
- Published
Description
This is a custom-designed wall/surface mount for the Zooz ZEN58 XS Relay, allowing for a clean, secure, and accessible installation.
The relay snaps firmly into place using dual retention clips, combined with a snug friction fit along the sides. This ensures the device stays securely mounted while still being removable when needed.
Features
-
Secure snap-in design (no fasteners required for the relay itself)
-
Dual clip retention + side friction fit
-
Clean, low-profile mounting solution
-
Designed specifically for the Zooz ZEN58 XS Relay
Print Settings
-
Material: PLA or PETG
-
Supports: Not required
-
Nozzle: 0.4mm
-
Layer Height: 0.20mm or 0.16mm (both tested)
-
Perimeters: Minimum 2 (recommended 4 for strength)
Notes
-
Printer calibration is important. This model uses tight tolerances to achieve a proper snap fit.
-
If your fit is too tight or too loose, adjust horizontal expansion or flow accordingly.
-
PETG is recommended for installations in warmer environments.
Installation
-
Mount the base to your wall or surface using appropriate screws.
-
Align the ZEN58 relay with the mount.
-
Press firmly until the relay snaps into place.
Removal:
Insert a small flat-head screwdriver into the bottom slot and gently use it as a lever. Apply minimal pressure to lift the relay out of the tray/walls holding it in place. Once released from the tray, the relay can be easily removed.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 388.2 KB
- Largest file
- 388.2 KB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-
New -

-

-
New -


