DUMMY 13 - CÁNH ROBOT THIÊN THẦN

Angel robot wings attachment for the Dummy 13 by Soozaphone.

Print Settings

• Print wings flat to bed with protrusions pointing up
• Layer Height 0.1-0.2mm
• Supports - None
• Brim - helps with the backpack for wings
• Print the Backback attachment standing up in the correct orientation.

Assembly

The 

• Backback Should connect to the hole in the back of the Dummy 13 Upper Torso. Tested on 130% & 160% model.
• Insert wings as a friction fit with the raised profile facing towards you. You can also glue them in place if needed.