Tấm đế gắn Masimo Rad-97 (VESA 75x75)

There are 2 models included.

The first is a base plate designed to attach to the bottom of the a Masimo Rad-97 device.  The spacing for the mounting points on the device are 75x75mm, or VESA75. M4 bolts of appropriate length are used to connect the plate to the device.

The second model is the interface between the plate and the system you are mounting the device to. In our case, we had a pole bracket with a offset square extrusion. This particular model is designed to slide over the square and lock into place. M5 bolts and nuts are used to attach the interface to the mounting plate. The M5 bolts and nuts should be recessed below the surfaces if the correct length is used.

Original print used PLA.  The bracket as seen in the photos was printed with PPS-CF. The Masimo puts off a bit of heat, probably not enough to truly soften PLA, but enough to weaken it over time.

Suggest you use a small hole offset to allow for differences in printers so your bolts slide in the holes cleanly.  The models include a bit of wiggle room but every printer is different.