
Bộ chuyển đổi Futaba BLS A600 cho VLV Aurora
- Downloads
- 4
- Likes
- 0
- Views
- 90
- Remixes
- 0
- Comments
- 0
Files 3 100.9 KB
- Wing_A600_Adapter_1775394658.stepSTEP · 42.7 KB
- Elevator_Servo_Slot_Jig_1775394659.stepSTEP · 16.8 KB
- Stab_A600_Adapter_1775394660.stepSTEP · 41.4 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #288116
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
Three parts are included in this upload.
The wing adapters just glue straight into the opening that comes with the kit. You may need to slightly open it up as the fit is very tight. Just glue them down with epoxy to the existing frame, and drill through for the A600 screw holes.
The stab servo adapters just glue on top of the existing rib. Use the holes that are larger than the A600 mount holes to align to the existing rib holes by inserting a T-pin or similar while gluing so you know you are located in the same spot as the factory holes.
The Slot jig is to provide a guide to Dremel out a slot for the servo arm. You will need two of them, mirrored one for each side. You can mirror them in the print software (Orca etc.). Use your eye and line the centre of the slot with the output shaft, and then tape in place and use a Dremel and grinding tool to open the slot up. Double check your measurements before cutting anything!
Print spec
- Formats
- step
- Model files
- 3
- Total size
- 100.9 KB
- Largest file
- 42.7 KB
0 comments
You may also like 12 models
See all-
New -

-

-

-
New -

-

-

-

-

-

-


