Vỏ bảo vệ (Case) cho Radxa Rock Pi E

Simple case for Radxa Rock Pi E SBC that doesn't need any screws. The SBC slips into the gaps in corner reinforcements in the case and the cap. The cap stays in place with a small protrusion that snaps into a groove in the case's inside wall. Slits in the case wall add some flex to make it easy to close and open.

I used PETG with maybe 70% honeycomb infill for the case and 30% for the cap. I cannot remember exactly.

The FreeCAD files are parameterized but a bit messy. They could be adapted to different measurements but some fixing may be needed then due to the mess.