Dụng cụ tháo lắp thước ngắm Glock (Glock Rear Sight Drift Tool)

This is a remix of @thatdude333's Beefy Glock Sight Pusher remix of @david49152 Beefy Glock Sight Press

Shout-out to Roman “The Glockfather” from the Taran Tactical team for the generous gift of a front and rear sight kit for the Glock 17. 

Storytime: 

After a nice reintroduction to competition shooting this weekend, I found myself with a set of Glock sights and no rear sight pushing tool. Rather than order one online, I decided to print a tool. As usual I looked to see if someone else has made one. They did. Digging through my toolbox, I realized I didn't have a few parts to complete the tool. Namely, the Everbilt Draw Bolt 1/4in-20 x 3-1/2in. So I made it easier to put together with garbage I found in my toolbox.

BOM: 

• 3/8-16 Hex Head Bolt, 3in length minimum. 3.25in shown in images
• #6 Flat Washer
• M4x25mm Screw
• M4 Nylock Nut… standard M4 nut works fine

Print Instructions:

ASA/ABS preferred. You might be able to get one use out of PETG+

• Frame: 75% Gyroid, +6 wall. Add supports to the screw holes. Print ON side up
• Slider: 100% Rectilinear +6 wall is fine. Add supports to the washer holes and overhang. Print on flat
• Handle: 25% Gyroid, +6 wall works OR 20% Hex, -all top & bottom layers so it looks sexy. Print with the hexagon pointed up.
• (Optional)Knob: Whatever, +6 wall, print with the smaller diameter side down

Other Notes: Upon assembly, you may notice the press-fit parts are tight. This is on purpose as I'm impatient and didn't want to add glue. This tool was intended to survive a few uses. So it's probably not too great for using it industrially.

Future Plans: Probably add tic marks… my proof of concept didn't have any, but they'd be handy for figuring out your sight alignment. 

If you like what I do, toss in a like. If you make the thing, give it a post. I'd love to hear your feedback.