Khung Terrarium cho nhện nhảy (Parametric OpenSCAD)

I made this frame a few years back.  I made the model in openscad and intended it to be fully parametric.  I wanted it to be able to be tweaked to a desired panel size so and to have various base shapes (triangle, square, pentagon , etc.).  I did not quite come back to finish the project, but wanted to upload the files in case someone could find them useful.  If i remember correctly i messed up some math some where so the outside of the assembled frame was slightly not square, i might of fixed it but i dont remember sorry.

I have include the files and photos of the assembled frame I believe I used. 

I made use of aquarium silicone glue in the hopes it would be non toxic to the jumping spiders I was keeping.  Make sure to include some ventilation holes to avoid condensation issues.  I melted holes and covered with mesh in mine, if i had to do it again i might instead cut the top or corners off the acrylic panels then cover with a mesh.

I was able to keep small jade plants in mine.  I made sure to seal the bottom very well and was very careful not to over water unless you incorporate some kinda of drainage.

Photo description:
First photo is of just the frame set together, the enclosure in the background was my first attempt and i no longer have those files. 

Second photo is with frames in place, i was trying to raise some ants in this photo.

note: i no longer have the terrarium so i am unable to take any more photos.