Đế giữ nam châm cho Echo Show 8 V2

Description 

Works with Echo Show 8 V2 - adds 15 degree tilt and lifts screen a few mm … couldn't find a model with magnets to hold it in place so quickly created this. 

Print … 

Easy to print - 

• PETG / PLA or whatever
• 0.24mm layer height 
• 15% infill 
• no supports 

(excuse slightly “meh” finish on print, yours will be far better I'm sure - filament was damp from factory!)

NOTE: when inserting magnets from underside, make sure you have the polarity right for the base of the echo show.

• 6x3mm version requires 2x magnets per hole to really hold the base nicely
• 10x3mm version created / added but not tested (would imagine 6 10mm magnets should be fine though - let me know in comments)

_HINT: to press magnets in to place get a steel hex/allen key or similar - sho_uld not need glue.

Filament tips accepted with thanks (clicky click)