Giá Đỡ Hạt Bơ (Avocado Seed Holder)

I was tired of sticking toothpicks in the seed that always felt out, so I designed this simple 4-part holder. It should work fine with the majority of glasses and jars.

There are two types of legs avalible:

• The normal one, intended for most applications.
• The long one. This one comes very handy when changing the water. It's long botton part raises the seed enought from the table to prevent this rolling out from the holder.

For a complete set, you will need to print three legs of one type and a core.

Since you may want to modify the model, apart from the .STL I also included the SOLIDWORKS 2020 files.

Print Settings

Printed in PETG, without supports or rafts, at 0.2mm resolution and 100% infill.

It also could be printed in PLA without a problem.

To print the legs, simply lay them on their side so that the angle is parallel to the print bed.

Assembly

The assembly is quite simple, just insert the legs into the core and put the avocado seed on top with a little water, as seen in the following gifs for the two types of legs:

Assembly process for the normal legs version ↑

Assembly process for the long legs version ↑