Bảng thẻ bài Mission cho Mistborn Deckbuilding Game

• 3x Mission Card Overlays (Of any of the versions, see edit below)
• 12x Bonus Indicators

Print off the three mission pieces in whatever combo you like. I suggest doing a filament swap at the last few layers to get the numbers to be more legible. These files fit the original cubes that came with the game at a 45 degree angle (see photos)

Then print up to 12 Bonus indicators to snap onto the rows/numbers that have the bonuses so they are easier to identify across the table.

Edit - February 26, 2025

• Added an additional variation for each of the 3 “Mission Card Overlays”, the ones with the “FilamentChange” in the name have had the decorative aspects and the numbers elevated to be .5mm higher than the cube rows. This will allow for manual filament changes to be performed on the print allowing for the nice contrasting look.
• Additional files from before ^ were .5mm above cube row. Just added a “v2” of the same at a .75mm higher than cube row.