
Khay Đỡ Mainboard MATX Cho Tủ Rack DeskPi Rackmate T2
- Downloads
- 6
- Likes
- 2
- Views
- 100
- Remixes
- 0
- Comments
- 0
Files 4 3 MB
- MATX_DeskPi_T2_V2_1776169716.stlSTL · 797.7 KB
- MATX_DeskPi_T2_V2_1776169718.stepSTEP · 755.6 KB
- MATX_DeskPi_T2_V1_1776169720.stlSTL · 801.6 KB
- MATX_DeskPi_T2_V1_1776169721.stepSTEP · 760.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #276369
- Category
- DIY
- Published
Description
WILL PROBABLY NOT WORK ON OTHER RACKS OTHER THAN THE RACKMATE T2 UNLESS YOUR SPACING BETWEEN BACK AND FRONT IS 10 1/4 INCHES OR 260.35MM
PCIE CARDS WILL NOT FIT WITH BRACKET INSTALLED
V1: Release
V2: Changed back cutout to not block motherboard IO
A tray to hold a MATX motherboard in a DeskPi Rackmate T2 10 inch rack.
Fits snug into the rack, you need quite a lot of room to put it in on an angle so I would put this in first before anything else. There is just enough clearance on the side walls to put the power supply under and feed the cables up. I had to modify my motherboard and remove the VGA port using a hot air rework station because it protruded to far out in the corner. On the front there is a 16mm hole for a power button.
Print spec
- Formats
- stepstl
- Model files
- 4
- Total size
- 3 MB
- Largest file
- 801.6 KB
0 comments
You may also like 12 models
See all-
New -
New -

-

-

-

-
New -

-

-

-
New -


