
Nắp che lỗ dưới đế máy in P1P
- Downloads
- 125
- Likes
- 24
- Views
- 453
- Remixes
- 0
- Comments
- 6
Files 1 988.6 KB
- HoleCoverV3_1766549172.stlSTL · 988.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #27553
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Public Domain
Description
Designed this because I had some filament stuck in those 4 tiny holes located at each corner at the base of the printer.
Best printed higher quality for good tolerances
The cover is designed to be removed by just a fingernail. Should fall into place with ease.
(V3) Different variation, may be harder to remove from the hole but should provide sleeker looks and less disturbance during prints
Tips:
Wait for bed to cool below 35C before removing to prevent bending on the edges (the top is very thin and can bend easily with little heat)
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 988.6 KB
- Largest file
- 988.6 KB
6 comments
You may also like 12 models
See all-

-
New -

-

-

-

-

-

-

-

-

-


