Bar đèn LED cho vỏ máy in 3D Prusa

I have taken the light bar that I had on my MK3s and added clips and a diffuser for use vertically in the Prusa Enclosure - in the same place the ‘official’ one is placed

The main light bar was originally remixed from Bofh_1377's design over on thingiverse, to use generic 8mm stick on LED strip. Everything else was from his design. This now uses my light bar design, the original end caps designed by him, and new clips to hold it into the enclosure.

I have also created a new clip on diffuser to help even out the light.

Both the bar and the diffuser will need to be printed out diagonally.

I printed all of the parts in PETG. Black for the bar and caps, clear / translucent for everything else. I glued the caps on, as they where a little loose.

The clips are screwed in place with som M3 x 8mm cap head screw through the holes in the enclosure upright. the light bar is clipped in place and hangs off the top clip, as the cap rests on it. The diffuser clips over the bar.

everything should be able to be printed without supports. .3 layer height and 15% infill should be fine. 

My other Prusa Enclosure prints:

https://www.printables.com/model/563199-octopi-mount-for-prusa-enclosure

https://www.printables.com/model/484200-power-distribution-for-prusa-enclosure