Skip to main content
F3D
Nắp lưng Lilygo T-Embed hỗ trợ hai ăng-ten 1

7 images

Giáo Dục

Nắp lưng Lilygo T-Embed hỗ trợ hai ăng-ten

By AlexG_1319651

Downloads
155
Likes
21
Views
888

Files 2 522 KB

  • t-embed_Back_Case_1776548141.stlSTL · 376.6 KB
  • t-embed_SMA_Cover_1776548143.stlSTL · 145.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

I have installed an NRF24 module in my Lilygo T-Embed, so I created a back cover to accommodate two external antennas for 2.4GHz and 433MHz. Also it can be used if you like to install two external antennas to improve signal coverage.

It consists of a back cover to which you will need to add the SMA-IPX connectors and 4 magnets of 8x2mm, although it is also possible to secure it with screws.

Conectors: 5 unids/lote IPX a SMA, Cable conector SMA hembra a UFL/u.FL/IPX/IPX, conjunto de adaptador coaxial RF Cable en espiral 1,13 MM RP-SMA-KY - AliExpress 13

Magnets: Disco magnético de neodimio de 8x2mm, revestimiento de níquel y cobre, imanes de tierras raras, redondos, adecuados para oficina, pizarra blanca - AliExpress 15

For printing, the best way is with the internal cover facing down. Once of the SMA connectors are placed, they can be covered with the covers using a bit of adhesive. I recommend using PETG or a similar material and a 100% infill to make the support for the connectors and the assembly as rigid as possible.

In addition, I have created a 6x4mm housing for a micro push button that I have soldered in parallel with the BAT of the board to avoid opening the device too often.

If you need a guide for the installation process of the module, you can find all the information here:

https://github.com/Xinyuan-LilyGO/T-Embed-CC1101/issues/30

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
522 KB
Largest file
376.6 KB

0 comments

See all