
Bộ giá đỡ vệ sinh Nozzle cho Voron Trident
- Downloads
- 46
- Likes
- 15
- Views
- 411
- Remixes
- 1
- Comments
- 0
Files 2 7.5 MB
- Nozzle_Wiper_Mount_VT_1774507499.stlSTL · 1.2 MB
- Nozzle_Wiper_Mount_VT_0.2mm_ABS_MK3S_4h15m_1774507501.gcodeGCODE · 6.3 MB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #263718
- Category
- Máy In 3D
- Published
Description
Been searching for a nozzle wiper mount to add to my Voron Trident. It seems there are my models for the Voron 2.4 but only limited options for the Trident. so I came up with this.
It is mountable on the bed extrusion using 3 M5x12 from below the heat bed (M5 sliding T-Nut used). Additionally 2 socket head M5x12 are used as a separation so it does not stick to the heat bed.
I have used 2 x Silicon Nozzle brushes (from Amazon) and added custom macros to the PRINT_START and PRINT_END so that the nozzle is wiped at the start using one brush and wiped again after the print using the second. Adding second brush on the opposite side also makes it easier to align the build plate as the socket head screws stop the plate from sliding beyond the heat bed.
items required for this model:
- 3 X M5x12 round head machine screws
- 3 X M5 Sliding T-Nuts
- 2 X M5x12 Socket head machine screws
- 2 X Silicon Brush
link to the silicon wiper Brush:
https://www.amazon.com/dp/B0DRBZK7RZ?ref=ppx_yo2ov_dt_b_fed_asin_title
I have printed the model with ABS using the same recommended settings for all Voron parts
Print spec
- Formats
- gcodestl
- Model files
- 2
- Total size
- 7.5 MB
- Largest file
- 6.3 MB
0 comments
You may also like 12 models
See all-

-
New -

-

-

-
New -

-

-
New -
New -

-



