
Tay đòn Swing Arm cho Voron Trident
Remix of Prusa SwingArm - Bản phát hành mã nguồn mở By Prusa3D
- Downloads
- 109
- Likes
- 35
- Views
- 809
- Remixes
- 0
- Comments
- 0
Files 3 922.9 KB
- base_1774163691.stlSTL · 199.8 KB
- swing_arm_1774163692.stlSTL · 132.9 KB
- swing_arm_1774163693.f3dF3D · 590.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #261017
- Category
- Máy In 3D
- Published
Description
For my Voron Trident 300 I want to get rid of the cable-chains and go for umbilical. Unfortunatly umbilical never worked out for me, as I wanted. I used a Tophat for my Trident, but was not happy with it (hard to seal, more air to heat, …). With the swing-arm there is no more need for a Tophat.
Luckily I found the swing-arm from Prusa and I remixed it to be useable on a Trident. The base and the arm are fully printable (use supports).
For the assembly you need the following hardware:
- 2x F695-2RS Bearings (5 mm x 13 mm x 4 mm)
- 1x M5 Heatset-Insert (~9mm long)
- 1x M5x30
- 2x M3 Hammerhead/Rollin
On my assembly, the two bearings have friction - therefore you maybe can't fully tighten the screw and leave it a bit loose. Use some Loctite to not unscrew.
There is also a hole in the front of the arm, to use piano-wire and a hole for a heatset to lock the wire (not tested, because it works for me without the wire).
Important:
Please note, that you have to feed the PTFE-tube for your filament from the side (I drilled a whole in the side-panel).
Printed with Polymaker ASA, bearings have a good fit on my assembly.
At the moment I'm working on new version with smaller bearings and a second arm to prevent sagging of the arm. This version is fully working, at least for me.
Update:
22.05.2025: Added Step-File (had to redraw completly..)
Print spec
- Formats
- f3dstl
- Model files
- 3
- Total size
- 922.9 KB
- Largest file
- 590.2 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -
New -
New -

-
New -

-

-

-


