Skip to main content
F3D
Đế sạc MagSafe cho Volvo EX90 1

2 images

DIY

Đế sạc MagSafe cho Volvo EX90

By jgentry

Downloads
3
Views
103

Files 2 4.5 MB

  • EX90_MagSafe_Charger_2X_1774034434.stlSTL · 2.6 MB
  • EX90_MagSafe_Charger_1X_1774034435.stlSTL · 1.9 MB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#259713
Category
DIY
Published

Description

Update 03/15/2026: Tightened up the MagSafe hole.

There are two USBC charge ports in the center area under the main display on the dashboard.  This model adds a way to use this space for MagSafe charging.  There are 1X and 2X versions depending on how many MagSafe chargers you want down there.  This was designed for the 25W MagSafe charger, the one with the braided cable.  The older 15W version, the one with the plastic cable, will not fit.  The back plate of the model needs to fit over the elastic band to ensure the model does not fall over.

It prints at a 45° angle so I would recommend adding a brim to ensure it stays stuck to the print bed.  No supports needed.  You may need to play around with the scale to get the MagSafe diameter correct.  You can always use some Super Glue to ensure it stays put.  I would recommend printing in something that is heat tolerant like PETG or, even better, ASA to prevent having the model deform in the heat.

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
4.5 MB
Largest file
2.6 MB

0 comments

See all