Chậu cây tham số (Parametric Plant Pot)

Parametric Plant Pot & Vase Generator with Wall Patterns

A fully parametric plant pot and vase generator with 7 surface pattern options. Every dimension, pattern, and drainage configuration is controlled through simple parameters — no CAD skills needed, just adjust values and export.

Features

• Fully hollow with open top and rounded inner bottom corners

• 7 wall pattern styles: none, spiral_ridges, wave_bands, hexagon_mesh, organic_dimples, twisted_flutes, honeycomb

• Patterns are constrained to the straight wall zone — the rim curves stay clean

• Smart auto-drain system: set a coverage percentage (% of bottom area as holes) and hole size (5–13mm) and count are calculated automatically.

• Holes are distributed in concentric rings with proper spacing — no overlaps, no holes too close to the wall

• Rounded bottom exterior edge via Minkowski for a refined look

• Optional wall twist angle for organic silhouettes

• Pattern intensity, frequency, scale, and height modulation all independently adjustable

Parameters

Parameter

Description

bottom_diameter / top_diameter

Controls taper — equal = cylinder, different = cone

height

Total pot height in mm

wall_thickness

Shell thickness in mm

bottom_edge_radius

Exterior bottom rounding

pattern_type

One of 7 patterns (or "none")

pattern_intensity

Feature depth/height in mm

pattern_frequency

How many repeats around/along the wall

pattern_scale

Overall pattern size multiplier

pattern_height_modulation

Gradually increases pattern intensity toward the top

twist_angle

Rotates the top relative to the bottom

drain_holes

Enable/disable drainage

drain_coverage

% of bottom area that becomes holes (1–50%)

---

• Print Settings

  • Layer height: 0.2mm

  • Walls: 3+ perimeters

  • No supports needed for most patterns (overhangs are on the exterior surface)

  • Twisted flutes and organic dimples may benefit from support if intensity > 3mm

  • Material: PLA, PETG, or ASA recommended for outdoor use

Customizer compatible — open in OpenSCAD and play with the paramethers

This is an updated version of what it is in : https://makerworld.com/en/models/1833350-plant-pot-parametric-scad