Skip to main content
F3D
Bộ chuyển đổi pin Canon NB-2L sang USB-C 1

7 images

DIY

Bộ chuyển đổi pin Canon NB-2L sang USB-C

By Modellaner_57403

Downloads
1
Views
64

Files 4 261.9 KB

  • usbc-housing-back_1773780779.stlSTL · 85.3 KB
  • usbc-housing-front_1773780780.stlSTL · 70.4 KB
  • nb-2l_-_base_1773780781.stlSTL · 56.5 KB
  • nb-2l_-_top_1773780782.stlSTL · 49.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

!!! Attention: Build and use this thing at your own risk. Make sure you have the knowledge for this. !!!

If you get tired of changing the NB-2L batteries of your cameras, try this thing and power them with a compatible power bank or power supply for hours. :)

I've remixed the "NB-2L battery cover" from "huchasi" to create an adapter to use supported Canon cameras with a USB-C power source.

You will need the following things:

– Printed parts

– USB-C-Triggerboard (konfiguriert auf 9 V Ausgang)

– Tiny Step Down Module (HW-187, MINI-360)

  • 1 x M3 x 16 mm countersink screw

– 2 × M3 × 30 mm Allen-head screws

– 3 × M3 Nuts

– Cable, about 50 cm (2 poles)

– 2 × Zipties

  • some hot glue (to stick the USB-C trigger board and pole PCB in place)

– some isolating tape or heatshrink (to isolate the step-down module)

I've used a double-layered PCB and some 0.5 mm thick copper stripes to create the poles on the NB-2L battery dummy. Just mark the contact parts with a permanent marker and then etch it with your favourite acid. After cleaning with acetone (or similar), bend the copper stripes (3 of all) from one side of the PCB to the other and solder them to the PCB on both sides.

Solder a blob to the 9V pad of the USB-C trigger board.

Connect/solder the USB-C trigger board and step-down module as seen in pictures and make sure that they are isolated from each other if inserted in the housing (use the isolating tape or heat shrink).

Adjust the output voltage of the tiny step-down module to 7.5 V.

Category: Other

Read more Show less

Print spec

Formats
stl
Model files
4
Total size
261.9 KB
Largest file
85.3 KB

0 comments

See all