Skip to main content
F3D
Cốc trồng cây Planter Starter Cups - Phiên bản in siêu tốc 1

3 images

Đồ Gia Dụng

Cốc trồng cây Planter Starter Cups - Phiên bản in siêu tốc

Remix of Ly/Khay Ươm Mầm (Tự Tưới) Hình Bát Giác By mfischer79

By Zwom_3055277

Downloads
4
Likes
1
Views
66

Files 4 114.8 KB

  • Cup_Version_1_Part_1_1773766885.stlSTL · 30.8 KB
  • Cup_Version_1_Part_2_1773766885.stlSTL · 26.5 KB
  • Cup_Version_2_Part_1_1773766886.stlSTL · 30.8 KB
  • Cup_Version_2_Part_2_1773766887.stlSTL · 26.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Basic Idea

I really like mfischer79's Planter Starter Cups. But in order to save material and speed up printing time, I wanted a thinner-walled version. This is it. It comes in two versions:

  • Version 1: wall thickness of 1.2mm

  • Version 2: wall thickness of 0.8mm

Both versions are compatible with mfischer79's tray. So you don't need to print a different one for them. (You might want to cut off about 1mm at the bottom of the tray model though, to make it also print faster.)

But how much can you actually save?

Just look at the graph below. I got the time from my slicer and the weight from actually weighing my two versions + the original.

The actual numbers are also listed in the table below:

Time

Weight

Version 1

  -20%

  -27%

Version 2

  -32%

  -47%

Please be advised: those values are valid for my printer with my settings. Your mileage may vary, as they say.

So which version should you print?

Well... depends on your needs...

  • If you want a really sturdy print - use the original and none of my models. It really is the strongest of the three (as is to be expected).

  • If you're okay with a little less strength, but want to print a lot of them - maybe use my Version 1.  It cuts printing time by 20% and saves you about 1/4 of filament. This is the version I personally use.

  • If you don't need a lot of strength, but want to be fast and save material - you could use my Version 2. It cuts printing time by about 1/3 and saves almost half of the filament used. But it is quite a bit flimsy.

If you're unsure - you could print one of each and decide according to your requirements with the physical models in hand.

Read more Show less

Print spec

Formats
stl
Model files
4
Total size
114.8 KB
Largest file
30.8 KB

0 comments

See all