Bộ kẹp Irwin Quick Grip cho thanh ray máy cưa đĩa Scheppach

The clamps that come with the Scheppach track saw rail are a threaded type and I thought these Quick Grip clamps would be more convenient. Believe that the Scheppach tracks are different to Festool and Makita.

Assembly:

Remove the existing fixed jaw of the clamp.

Remove the soft jaw from the moving end of the clamp and drill a couple of holes in the the plate that the soft jaw normally clips on (using the Clamp Extender part as a template). Connect the Clamp Extender to the moving jaw using a couple of M3x12 bolts and nuts. Clip the soft jaw onto the end of the Clamp Extender.

Push the end of the clamp bar through the Clamp End part and fix in place with the 4mm bolt and nut from the original fixed jaw.

The Clamp End part will be strongest when printed on the flat side, but you will need some support under the slot. The Clamp Extender part should be ok printed flat end down without support.

Printed in PETG with 5 perimeters, 0.2mm layer height and 40% infill.