Skip to main content
F3D
Tháp hiệu chuẩn Pressure Advance Klipper V2 1

2 images

Máy In 3D

Tháp hiệu chuẩn Pressure Advance Klipper V2

By Fagge

Downloads
2,461
Likes
97
Views
7,719
Remixes
1

Files 1 2.4 KB

  • Klipper_Pressure_Advance_Tower_V2_1773640377.stlSTL · 2.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

I prefer this model better than the original.
Lightweight, fast, & easier to read.

Print:
1 Bottom layer
0.2mm layer height
1 Perimeter
0 Top layer
0 Infill

Set all speeds to 100mm/s, except the first layer speed. Use your default value.

Important in Prusaslicer:
Under cooling: Set to 0 "Slow down if layer print time is below"
Otherwise 100mm / s cannot be achieved.
And
Turn off "Lift Z", during retraction, so as not to falsely trigger the TUNING_TOWER COMMAND .... procedure.

Continue the procedure.
https://www.klipper3d.org/Pressure_Advance.html

For Direct drive extruder, I prefer to use FACTOR = .01, instead of FACTOR = .005.
The precision is good enough anyway, and the printing time goes twice as fast until you find the sweatspot.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
2.4 KB
Largest file
2.4 KB

0 comments

See all