Móc khóa và đồ chơi Fidget băng chuyền Factorio

A set of small Factorio styled belts. One 8-segment part has a hole at the end for a keyring and the others makes a great desk fidget toys. The longer ones will likely need to be printed at an angle to fit on the build plate. These are print-in-place with fairly tight tolerances. I printed mine on an Ender 3 V2 with a .4mm nozzle and was able to get them flexing without too much difficulty.

I changed the filament near the top to get the colored arrow. The keyring hole makes the segment a bit high limiting when the filament can be changed for that version but the final effect still looks alright.

Print Details

Layer Height

.16 mm works well in my testing
.12mm for the keyring if you want more layers for the colored arrows

Infill

5% Gyroid

Filament

Ender Gray PLA, Ender Yellow PLA, Ender Red PLA, Ender Blue PLA

This is a remix of the Factorio Belt Keychain by Demod. The changes I made were to remove the bars from the ending belt pieces, close the holes in the front of the fidget models, and make some excessively long variants.