Skip to main content
F3D
Vỏ hộp Arduino Mega cho hệ thống DCC-EX 1

6 images

DIY

Vỏ hộp Arduino Mega cho hệ thống DCC-EX

By Nebbish

Downloads
445
Likes
16
Views
2,732
Remixes
1

Files 7 1.8 MB

  • Arduino_Mega_Case-Bottom_1773428716.stlSTL · 97.2 KB
  • Arduino_Mega_Case-Bottom_-_With_Side_Access_for_Expansions_1773428717.stlSTL · 65.4 KB
  • Arduino_Mega_Case-Top_-_No_Display_1773428718.stlSTL · 41.6 KB
  • Arduino_Mega_Case-Top_-_With_Display_1773428719.stlSTL · 74.2 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

I recently made the switch from DCC++ to DCC-EX and with that I upgraded to the Arduino Mega, ESP-01 for wifi, and a .96" display to show the ip address. This system can also be connected via USB to a computer running JMRI if you need to edit settings, rosters, etc.

This case was designed to be a simple way to protect the components and provide a way of mounting them to a layout.

You will need to print one base and one of the covers. I've included 4 covers to suit different needs. One version has a spot for the display and the other does not. 2 of them have wording on the cover that reads “DCC COMMAND STATION”, the other two are blank. I've included 2 bases, one of them has an access hole for adding additional controllers for items like turnouts or turntables. There's also two slots for a zip tie to hold secure the wires.

My print settings:

material: PLA

layer height: .28

infill: 15%

Note: There are no screws for the display. (Update 1.17.23 - I printed a second one for my dad and found out that not all .96" displays have the same mounting hole spacing. I ended up using hot glue to secure his to the cover) To attach it, I put the display onto the cover and then melted the pins to hold it in place (See photo of back of display). The cover is pressure fit with one screw.

Read more Show less

Print spec

Formats
fcstdstl
Model files
7
Total size
1.8 MB
Largest file
627 KB

0 comments

See all