Giá treo webcam cho Neptune 4 (Pro)

This webcam holder was designed for the Rollei R-Cam 100 (as the original model) which is easy to activate on the Neptune 4 and  Neptunde 4 Pro (see lower in the description). 

Tried to find an angel where the nozzle is visible but have a more top view on the model. The holder attaches to the z axis and moves up with each layer to keep same view. (same as original). 

The relocation of the cam allows me to change also a bit the angle with the camera holder.

Material needed (suggested)

Mounting on z-axis: 

• 2x M4 hex screws (min 10mm), 
• 2x M4 Nuts
• 4x washers for protection  

Webcam: 

• 1/4 Inch (diameter 11 mm x height 21 mm) camera mounting screw - depending on your webcam, bit too long but the shortest i could find
• some distance for too long camera mounting screw (i used M6 nut and 3 washers)
• and of the cam ;-) 

Webcam activation

ssh to the terminal, activate 

sudo systemctl enable webcamd # enable the service
sudo systemctl start webcamd # start the webcam service

after this just configure in fluidd Settings→ Camera (enable the default or create your own). If you need you could adapt webcam.txt by your needs. 

As I'm new into 3d printing - christmas - its my first FreeCad drawing and share here.  

Happy printing and thx to Bernd for the great idea.