
Đế sạc MagSafe cho iPhone dùng ốp ví (Chế độ nằm ngang) [OpenSCAD]
- Downloads
- 3
- Likes
- 1
- Views
- 89
- Remixes
- 0
- Comments
- 0
Files 3 2.1 MB
- magsafe-horizonatal-phonestand_R3_1773262601.scadSCAD · 9.1 KB
- magsafe-horizonatal-phonestand_R3_1773262601.3mf3MF · 119.5 KB
- magsafe-horizonatal-phonestand_R3_1773262602.stlSTL · 2 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #244237
- Category
- Dụng Cụ Tiện Ích
- Published
Description
This stand allows iPhone MagSafe charging for an iPhone on a walletcase, with the walletcase fully open do that the iPhone can operate like a desk clock in Standby mode while charging. The other side of the wallet case folds back and drops into the slot behind the plate that the MagSafe charging puck mounts in. The Apple MagSafe puck press-fits easily and securely into the mount, and can also be pressed out from the back through the provided (pentagonal) hole. A rear slotted area holds coiled/folded-up excess cable to keep your desk neat. Also works for phones in non-wallet cases or no case at all.*
Prints without support; I use PLA but any rigid filament should do.
The OpenSCAD sourcee is provided for those who want to remix the model.
*for at least an iPhone 16, the phone can also be placed on the stand in portrait orientation between the front protrusions, and the MagSafe magnets will pull into position for charging.
Print spec
- Formats
- 3mfscadstl
- Model files
- 3
- Total size
- 2.1 MB
- Largest file
- 2 MB












