
Tự Làm Hệ Thống Thông Gió cho Enclosure Máy In 3D
- Downloads
- 217
- Likes
- 43
- Views
- 2,790
- Remixes
- 0
- Comments
- 0
Files 10 6.7 MB
- 100mm_Conn_to_Window_Mount_1772779007.stlSTL · 218 KB
- 100mm_Wall_Outlet_1772779008.stlSTL · 510.2 KB
- Window_Mount_100mm_1772779009.stlSTL · 223.3 KB
- Tophat_100mm_Inlet_1772779010.stlSTL · 94 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #239943
- Category
- Máy In 3D
- Published
Description
I set about building an extraction fan for my 3D printer enclosure as I do a lot of 3D printing and prototyping on my Voron 0.1 that sits next to me and it gets a bit stinky sometimes.
Did a YouTube video about this and these are the files for the final build. The Window Mount 100mm part is attached to a window blank wooden panel. There's also a wall outlet mount for the 100mm ducting as I later vented out through a wall in a different room.
The Outlet Diffuser is glued with epoxy to the Fan case.
M2 x 8mm self tapping screws are used to attach the Fan Case to the Tophat panel, and the Diffuser 100mm Conn to the Diffuser.
Tip: Attach the Diffuser 100mm Conn to the Diffuser before gluing to the Fan Case, otherwise its more tricky to screw the M2 screws in.
I printed in PETG with 0.2mm layer height and no supports.
Print spec
- Formats
- f3dstepstl
- Model files
- 10
- Total size
- 6.7 MB
- Largest file
- 1.7 MB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -
New -
New -
New -

-

-

-

