Hộp đựng Loop Earplugs nắp vặn (Screw-Top Lid Case)

After my old design came loose in the car, I made a screw-top version so that wouldn't happen again. Works with the OG Loops as well my Engages with the Mutes in. Should work for Experience, etc.

PETG is almost a necessity. It works much more smoothly. YMMV, of course.

Inner case must print with the keychain hole-side at the bottom. It needs minimal supports, and they are a pain to remove from where they anchor at the bottom. I suggest trying it with Organic/Tree supports and see how that goes.

Exterior case prints hole-up.

Prints shown in Prusa PETG, .2, 5 walls, 20% infill. I do not recommend printing them at the same time as PETG is pretty stringy.

As always, so much thanks to jecoffey for the original design and scanning.