Nắp nút nhấn tham số cho công tắc Push Button 7x7 / 8x8mm

Features

• A variety of button caps for square 7x7 / 8x8 / 8.5x8.5mm PCB push button switches
   
• Works with any switch with a 2x3mm square mount, either friction-fit or glued in place
   
• Choose from various shapes & sizes, or make your own with the included .f3d file
   
• Tolerances are adjustable to allow for a snap-fit on any printer 

Parts Needed

• 7x7mm / 8x8mm / 8.5x8.5mm PCB Push Button Switch

Printing Guidelines

• Layer height: 0.2mm
  Supports: No
  Brim: No
  Walls: 3+
  Infill: 10%+

Notes on Parameters:

• Parameters can be edited to any value, but very small or large numbers might result in errors or clipping:

  diameter: The diameter of the button (for polygons, this uses Fusion's 'Inscribed Polygon' function; for square, this is the length of each side)
  tolerance: The tolerance added to the 3x2mm mounting hole
  height: The height of the button cap
  fillet: Rounds off the top of the button to minimise sharp edges or create a domed effect
  polygonFillet: Rounds off the sides of the polygons to avoid sharp edges
  domeSquishFactor: Dome only - how much the button is compressed. Lower values = more squishing
  domeDiameter: Dome only - the diameter of the sphere used to make the button (also affects the height)