Skip to main content
F3D
Giá đỡ tai nghe có dây (Wired Earbud Holder) 1

7 images

Dụng Cụ Tiện Ích

Giá đỡ tai nghe có dây (Wired Earbud Holder)

By Devise3D

Downloads
142
Likes
12
Views
706
Remixes
1

Files 2 183.4 KB

  • Wired Earbud Holder.stlSTL · 117.1 KB
  • Wired Earbud Holder.objOBJ · 66.3 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

Do you have a tangled mess of wired earbuds lying around? This is the solution. This is a wired earbud holder.

  • Material: PLA or PETG
  • Supports: No
  • Orientation: Place the bottom flat on the build surface

Usage

All you have to do to use this earbud holder is placed the plug end of the earbuds into one of the larger slots on either the left or the right of the holder. Then wrap the earbuds around the holder until they do not go further. After that, the last step is to place the wire right below the earbuds into the smaller slots, on the top or the bottom of the holder. Depending on how you wound your earbuds, you may have to unwind them a little bit to get the earbuds secured into the smaller slots.

Tutorial

Remixing

If you would like to remix this model, the TinkerCAD file can be found here (or at https://www.tinkercad.com/things/bcp0Cuuy0Lu-earbud-holder?sharecode=rIwNhux-u8HhlzoTYZEMi82UrpNpat6dnRKl4w9KkEU).

If you enjoy this model, please leave a like and a comment. If you have any questions, concerns, or problems, please personally contact me.

If you want to support creation of more models like this one, you can subscribe to my Printables Club (at https://www.printables.com/@Devise3D#join:451) or you can purchase an individual model on CGtraitor (at https://www.cgtrader.com/devise3d).

Read more Show less

Print spec

Formats
objstl
Model files
2
Total size
183.4 KB
Largest file
117.1 KB

0 comments

See all