Skip to main content
F3D
Dry Box - PolyDryer Adapter (Adapter hộp sấy cho PolyDryer) 1

1 image

Máy In 3D

Dry Box - PolyDryer Adapter (Adapter hộp sấy cho PolyDryer)

Remix of Adapter PolyDryer Dual-Port cho Cereal Container Filament Drybox (Official Remix) By SparrowHawk_421862

By rslueb_1681189

Downloads
2
Likes
1
Views
60
Remixes
1

Files 3 1.2 MB

  • Dry_Box_-_PolyDryer_Adapter_1772696640.stepSTEP · 268.8 KB
  • Dry_Box_-_PolyDryer_Adapter_1772696641.f3dF3D · 455.2 KB
  • Dry_Box_-_PolyDryer_Adapter_1772696642.stlSTL · 498.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Details

Model ID
#237487
Category
Máy In 3D
Published

Description

This model was inspired by @GunplaMark's, @SparrowHawk's, and  @endri's adapters for the PolyDryer. I had trouble aligning the vents on the PolyDry with the holes on the cereal container. It was cumbersome to remove the cereal container from the the dryer because the seals were so tight.

This version was created from scratch as a single model that eliminates the alignment problem - at least for the cereal containers that I use. I also slightly increased the size of the vent holes so the container could be easily lifted off and separated from the dryer. I haven't noticed any leakage around the seals, but a small amount shouldn't have a significant effect on performance. The big hole in the middle is simply an attempt to save material.

I printed this with ASA which tends to warp on such a long piece. Wide brims helped eliminate this problem.

See @SparrowHawk's remix for the hex gasket ring and seal. The Fusion project is included so tweaks can be easily made to handle cereal container variations.

Read more Show less

Print spec

Formats
f3dstepstl
Model files
3
Total size
1.2 MB
Largest file
498.8 KB

0 comments

See all