
DIY
Ngăn kéo Gridfinity “Poor man's” slim (tiết kiệm filament) v4
Remix of Hệ thống ngăn kéo mô-đun Gridfinity By ChippWalters
- Downloads
- 206
- Likes
- 44
- Views
- 1,084
- Remixes
- 0
- Comments
- 0
Files 2 19.1 MB
- drawer_5x3_light_1772671973.fcstdFCSTD · 18.9 MB
- drawer_5x3_light-Body_1772671975.3mf3MF · 188.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #236058
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
rev. 4:
- improved .FCstd file
- now wall pockets are parametric!
rev. 3:
- removed some pockets from the backplate for more strength
rev. 2:
- made thicker grid as very thin walls between pattern is somewhat difficult to print, I suspect filament overheating in the nozzle (maybe lowering temperature could fix this)
- backwall is now somewhat parametric, you can change spacing and number of iterations of the pocket pattern (will do the same for sidewalls in near future
This is poor man's drawer for Chipp's Gridfinity modular drawer system:
- all mesh structure walls but the front one
- pockets under bins
- around 36% less filament compared to original
- around 5% more print time compared to original on MK4S
- test your printer with this very fine walls model
I went down to 51g of PLA compared to 80g original drawer design with 0.2mm layer height, 1 perimeter, 5% 3D honeycomb infill, 3 top and 2 bottom shells.
It slides.
I have attached a FreeCAD-1.0beta .fcstd file if you like to tinker with my stuff.
Print spec
- Formats
- 3mffcstd
- Model files
- 2
- Total size
- 19.1 MB
- Largest file
- 18.9 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-
New -

-

-

-

-

-


