Thanh giằng hông Creality K1 Max (Side Braces)

Version 1.2 (alpha)

Re-install using M3x18 screws - do not use too long of screws as they can hit the belt or corner blocks.

If printing in ABS you MUST use 99.5% shrinkage setting in Orca (or similar) for the filament setting.

Printed with 5 walls and 20% gyroid infill these were about 85g of filament for each corner

Kudos to D3D for the original design. I built a digital replica of the side panel and laid it over the K1 side brace and extended the model/re-created the screw holes to fit. 

This has been test fit on my K1 Max with success. Please do a test print first using just a few layers to verify fitment based on shrinkage settings.

Changelog:

Version 1.0 : Uploaded initial model

Version 1.1 : Removed recessed holes from top/bottom center screw location (K1 does not have a screw here so on the K1 the pieces just bolted together)

Version 1.2 : Increased height of lower left/lower right pieces by .1mm, decreased width of top left piece by .05mm