Hộp đựng du lịch cho bàn phím split Totem Wireless

*DISCLAIMER: This case is not completely flush with the keyboard. There is about 1mm of total play in between the case and the keyboard. because of this, I recommend sticking cut-to-size rubber feet on the sides of the keyboard or case wall to increase friction. See last picture for illustration*

This travel case was explicitly designed for GEIGEIGEIST's Totem Keyboard case and hardware. This case considers the rubber stands on the bottom of the totem case and any magnetic USB-C charger insert. (SEE IMAGES)

My Totem uses the dongle setup for increased battery life. 
See:
https://github.com/eigatech/zmk-config/tree/totem-dongle
https://www.printables.com/model/522586-seeed-xiao-ble-case

I printed it at 0.2 layer height with no supports and 20% infill. I bought these magnets, but any 6x3mm circular magnet should work.

Inspired by @Rhynier_476301's Corne travel case