Ốp bảo vệ cho máy đọc ebook Kobo Libra Colour

Protective Case for ebook reader Kobo Libra Colour.

I did not find any suitable case for this new reader so I made this simple one.

Just slide it in, it should snap in by the wider end where USB charging port is (just be careful when sliding over the buttons)

When sliding the reader out, I found that the best way is to support the lower part with fingers and then apply a little force downward with thumb and after that slide it out with the thumb (see last image)

I did not put the cutout in the middle to avoid the buttons.

Printed with ordinary PLA, recommend using brim